ATtiny13A datasheet(99/174 Pages) ATMEL

99 / 174 page

8126D–AVR–11/09

ATtiny13A

If the EEPROM is written in the middle of an SPM Page Load operation, all data loaded will be

lost.

16.3 Performing a Page Write

To execute Page Write, set up the address in the Z-pointer, write “00000101” to SPMCSR and

execute SPM within four clock cycles after writing SPMCSR. The data in R1 and R0 is ignored.

The page address must be written to PCPAGE. Other bits in the Z-pointer must be written to

zero during this operation.

Note:

The CPU is halted during the Page Write operation.

16.4 Addressing the Flash During Self-Programming

The Z-pointer is used to address the SPM commands.

Since the Flash is organized in pages (see Table 17-5 on page 105), the Program Counter can

be treated as having two different sections. One section, consisting of the least significant bits, is

addressing the words within a page, while the most significant bits are addressing the pages.

This is shown in Figure 16-1. Note that the Page Erase and Page Write operations are

addressed independently. Therefore it is of major importance that the software addresses the

same page in both the Page Erase and Page Write operation.

Figure 16-1. Addressing the Flash During SPM(1)

Note:

1. The variables used in Figure 16-1 are listed in Table 17-5 on page 105.

Bit

151413121110

ZH (R31)

Z15

Z14

Z13

Z12

Z11

Z10

ZL (R30)

Z7Z6Z5Z4Z3Z2Z1Z0

765

43210

PROGRAM MEMORY

Z - REGISTER

BIT

ZPAGEMSB

WORD ADDRESS

WITHIN A PAGE

PAGE ADDRESS

WITHIN THE FLASH

ZPCMSB

INSTRUCTION WORD

PAGE

PCWORD[PAGEMSB:0]:

PAGEEND

PAGE

PCWORD

PCPAGE

PCMSB

PAGEMSB

PROGRAM

COUNTER

ATtiny13A 데이터시트(PDF) 99 Page - ATMEL Corporation

ATtiny13A 데이터시트(HTML) 99 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL