DM562AP datasheet(18/48 Pages) DAVICOM

18 / 48 page

DM562AP

V.90 Integrated Data/ Fax/Voice/Speakerphone

Modem Device Single Chip with Memory Built in

Final

Version: DM562AP-DS-F03

Bit 1: This bit enables the Transmitter Holding

Bit 2: This bit enables the Receiver Line Status

Interrupt when set to logic 1.

Bit 3: This bit enables the MODEM Status Interrupt

when set to logic 1.

Bit 4-7: Not used

Interrupt Identification Register (IIR): Address 2

Reset State 01h, Read only

Bit7

Bit6 bit5 bit4

bit3

bit2

bit1

bit0

FIFO

Enable

D3:

INTD2

D2:

INTD1

D1:

INTD0

D0:

int

Pending

In order to provide minimum software overhead

during data transfers, the virtual UART prioritizes

interrupts into four levels as follows: Receiver Line

Status (priority 1), Receiver Data Available (priority 2),

Character Timeout Indication (priority 2, FIFO mode

only), Transmitter Holding Register Empty (priority 3),

and Modem Status (priority 4).

The IIR register gives prioritized information

regarding the status of interrupt conditions. When

accessed, the IIR indicates the highest priority

interrupt that is pending.

Bit 0: This bit can be used in either a prioritized

interrupt or polled environment to indicate

whether an interrupt is pending. When this bit is

logic 0, an interrupt is pending, and the IIR

contents may be used as a pointer to the

appropriate interrupt service routine. When bit

0 is logic 1, no interrupt is pending, and polling

(if used) continues.

Bit 1-2: These two bits of the IIR are used to identify

the

highest

priority

interrupt

pending,

indicated in the table below.

Bit 3: In character mode, this bit is 0. In FIFO mode,

this bit is set, along with bit 2, when a timeout

interrupt is pending.

Bit 4-6: Not used

Bit 7: FIFO always enabled.

Interrupt Identification Register (IIR): Address 2 (continued)

D3 D2

D0 Priority Level

Interrupt Type

Condition

Reset

Highest

Receiver Line

Status

Overrun Error, Parity Error,

Framing Error or Break

Interrupt

Reads the Line Status

Second

Receiver Data

Available

Receiver Data Available or

Trigger Level Reached

Reads the Receiver Buffer

Dropped Below the

threshold value

Second

Character

Timeout Indication

No characters have been

read from or written to the

Rx FIFO during

programming time interval,

and the Rx FIFO is not

empty

Reads The Receiver Buffer

Third

Transmitter

Holding Register

Empty

Ready to accept new data

for transmission

Reads the IIR Register or

(if source of interrupt)

Writes To The Transmitter

Holding Register

Fourth

Modem Status

Clear to Send, Data Set

Ready, Ring Indicator or

Data Carrier Detected

Reads the Modem Status

Nov. 09, 2007

DM562AP 데이터시트(PDF) 18 Page - Davicom Semiconductor, Inc.

DM562AP 데이터시트(HTML) 18 Page - Davicom Semiconductor, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

데이터시트 다운로드

링크 URL