12C508 datasheet(42/113 Pages) MICROCHIP

42 / 113 page

PIC12C5XX

DS40139E-page 42

FIGURE 8-11: TIME-OUT SEQUENCE ON POWER-UP (MCLR TIED TO VDD): SLOW VDD RISE TIME

VDD

MCLR

INTERNAL POR

DRT TIME-OUT

INTERNAL RESET

TDRT

When VDD rises slowly, the TDRT time-out expires long before VDD has reached its final value. In

this example, the chip will reset properly if, and only if, V1

≥ VDD min.

8.5

Device Reset Timer (DRT)

In the PIC12C5XX, DRT runs from RESET and varies

based on oscillator selection (see Table 8-5.)

The DRT operates on an internal RC oscillator. The

processor is kept in RESET as long as the DRT is

active. The DRT delay allows VDD to rise above VDD

min., and for the oscillator to stabilize.

Oscillator circuits based on crystals or ceramic

resonators require a certain time after power-up to

establish a stable oscillation. The on-chip DRT keeps

the device in a RESET condition for approximately 18

ms after MCLR has reached a logic high (VIHMCLR)

level. Thus, programming GP3/MCLR/VPP as MCLR

and using an external RC network connected to the

MCLR input is not required in most cases, allowing for

savings in cost-sensitive and/or space restricted

applications, as well as allowing the use of the GP3/

MCLR/VPP pin as a general purpose input.

The Device Reset time delay will vary from chip to chip

due to VDD, temperature, and process variation. See

AC parameters for details.

The DRT will also be triggered upon a Watchdog

Timer time-out. This is particularly important for

applications using the WDT to wake from SLEEP

mode automatically.

8.6

Watchdog Timer (WDT)

The Watchdog Timer (WDT) is a free running on-chip

RC oscillator which does not require any external

components. This RC oscillator is separate from the

external RC oscillator of the GP5/OSC1/CLKIN pin

and the internal 4 MHz oscillator. That means that the

WDT will run even if the main processor clock has

been stopped, for example, by execution of a SLEEP

instruction. During normal operation or SLEEP, a WDT

reset or wake-up reset generates a device RESET.

The TO bit (STATUS<4>) will be cleared upon a

Watchdog Timer reset.

The

WDT

can

permanently

disabled

programming the configuration bit WDTE as a ’0’

(Section 8.1). Refer to the PIC12C5XX Programming

Specifications to determine how to access the

configuration word.

TABLE 8-5:

DRT (DEVICE RESET TIMER

PERIOD)

Oscillator

Configuration

POR Reset

Subsequent

Resets

IntRC &

ExtRC

18 ms (typical)

300 µs (typical)

XT & LP

18 ms (typical)

12C508 데이터시트(PDF) 42 Page - Microchip Technology

12C508 데이터시트(HTML) 42 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL