STA015T datasheet(11/56 Pages) STMICROELECTRONICS

11 / 56 page

Obsolete

Product(s)

- Obsolete

Product(s)

11/56

STA015

proper operation BIT_EN line should be toggled only when SCKR is stable low (for both SCLK_POL con-

figuration). The possible configurations are described in Fig. 8.

3.2 GPSO Output Interface

In order to retrieve ADPCM encoded data a General Purpose Serial Output interface is available (in

TQFP44 and LFBGA64 packages only). The maximum frequency for GPSO_SCKR clock is the DSP sys-

tem clock frequency divided by 3 (i.e. 8.192 MHz @ 24.58MHz). The interface is based on a simple and

configurable 3-lines protocol, as described by figure 10.

3.3 PCM Output Interface

The decoded audio data are output in serial PCM format. The interface consists of the following signals:

SDO

PCM Serial Data Output

SCKT

PCM Serial Clock Output

LRCLK

Left/Right Channel Selection Clock

The output samples precision is selectable from 16 to 24 bits/word, by setting the output precision with

PCMCONF (16, 18, 20 and 24 bits mode) register. Data can be output either with the most significant bit

first (MS) or least significant bit first LS), selected by writing into a flag of the PCMCONF register.

Figure 9 gives a description of the several STA015 PCM Output Formats. The sample rates set decoded

by STA015 is described in Table 1.

To enable the GPSO interface bit GEN of GPSO_ENABLE register must be set. Using the GPSO_CONF

GPSO_SCKR input clock; the GPSO_REQ request signal polarity (usually connected to an MCU interrupt

line) can be configured as well.

Figure 9. PCM Output Formats

Table 1. MPEG Sampling Rates (KHz)

MPEG 1

MPEG 2

MPEG 2.5

44.1

22.05

11.025

STA015T 데이터시트(PDF) 11 Page - STMicroelectronics