ATSAM3U datasheet(33/62 Pages) ATMEL

33 / 62 page

6430CS–ATARM–09-Apr-10

SAM3U Series

9.1.3.6

Calibration Bits

NVM bits are used to calibrate the brownout detector and the voltage regulator. These bits are

factory configured and cannot be changed by the user. The ERASE pin has no effect on the cal-

ibration bits.

9.1.3.7

Unique Identifier

Each device integrates its own 128-bit unique identifier. These bits are factory configured and

cannot be changed by the user. The ERASE pin has no effect on the unique identifier.

9.1.3.8

Fast Flash Programming Interface

The Fast Flash Programming Interface allows programming the device through either a serial

JTAG interface or through a multiplexed fully-handshaked parallel port. It allows gang program-

ming with market-standard industrial programmers.

The FFPI supports read, page program, page erase, full erase, lock, unlock and protect

commands.

The Fast Flash Programming Interface is enabled and the Fast Programming Mode is entered

when TST, NRSTB and FWUP pins are tied high during power up sequence and if all supplies

are provided externally (do not use internal regulator for VDDCORE). Please note that since the

FFPI is a part of the SAM-BA Boot Application, the device must boot from the ROM.

9.1.3.9

SAM-BA

® Boot

The SAM-BA Boot is a default Boot Program which provides an easy way to program in-situ the

on-chip Flash memory.

The SAM-BA Boot Assistant supports serial communication via the UART and USB.

The SAM-BA Boot provides an interface with SAM-BA Graphic User Interface (GUI).

The SAM-BA Boot is in ROM and is mapped in Flash at address 0x0 when GPNVM bit 1 is set

to 0.

9.1.3.10

GPNVM Bits

The SAM3U features three GPNVM bits that can be cleared or set respectively through the com-

mands “Clear GPNVM Bit” and “Set GPNVM Bit” of the EEFC User Interface.

The SAM3U4 is equipped with two EEFC, EEFC0 and EEFC1. EEFC1 does not feature the

GPNVM bits. The GPNVM embedded on EEFC0 applies to the two blocks in the SAM3U4.

9.1.4

Boot Strategies

The system always boots at address 0x0. To ensure a maximum boot possibilities the memory

layout can be changed via GPNVM.

Table 9-1.

General-purpose Non-volatile Memory Bits

GPNVMBit[#]

Function

Security bit

Boot mode selection

Flash selection (Flash 0 or Flash 1) Only on SAM3U4 (256 Kbytes internal

Flash version)

ATSAM3U 데이터시트(PDF) 33 Page - ATMEL Corporation

ATSAM3U 데이터시트(HTML) 33 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

데이터시트 다운로드

링크 URL