WM8750CLSEFLSLASHR datasheet(22/65 Pages) WOLFSON

22 / 65 page

WM8750L

Production Data

PD, Rev 4.4, August 2012

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R1 (01h)

Right Channel

PGA

RIVU

Right Volume Update

0 = Store RINVOL in intermediate

latch (no gain change)

1 = Update left and right channel

gains (right = RINVOL, left =

intermediate latch)

RINMUTE

Right Channel Input Analogue Mute

1 = Enable Mute

0 = Disable Mute

Note: RIVU must be set to un-mute.

RIZC

Right Channel Zero Cross Detector

1 = Change gain on zero cross only

0 = Change gain immediately

5:0

RINVOL

[5:0]

010111

( 0dB )

Right Channel Input Volume Control

111111 = +30dB

111110 = +29.25dB

. . 0.75dB steps down to

000000 = -17.25dB

R23 (17h)

Additional

Control (1)

TOEN

Timeout Enable

0 : Timeout Disabled

1 : Timeout Enabled

Table 9 Input PGA Software Control

ANALOGUE TO DIGITAL CONVERTER (ADC)

The WM8750L uses a multi-bit, oversampled sigma-delta ADC for each channel. The use of multi-bit

feedback and high oversampling rates reduces the effects of jitter and high frequency noise. The ADC

Full Scale input level is proportional to AVDD. With a 3.3V supply voltage, the full scale level is 1.0

Volts r.m.s. Any voltage greater than full scale may overload the ADC and cause distortion.

ADC DIGITAL FILTER

The ADC filters perform true 24 bit signal processing to convert the raw multi-bit oversampled data

from the ADC to the correct sampling frequency to be output on the digital audio interface. The digital

filter path is illustrated in Figure 9.

FROM ADC

DIGITAL

HPF

DIGITAL

FILTER

TO DIGITAL

AUDIO

INTERFACE

DIGITAL

DECIMATOR

ADCHPD

Figure 9 ADC Digital Filter

The ADC digital filters contain a digital high pass filter, selectable via software control. The high-pass

filter response is detailed in the Digital Filter Characteristics section. When the high-pass filter is

enabled the dc offset is continuously calculated and subtracted from the input signal. By setting

HPOR, the last calculated dc offset value is stored when the high-pass filter is disabled and will

continue to be subtracted from the input signal.

If the DC offset is changed, the stored and

subtracted value will not change unless the high-pass filter is enabled. This feature can be used for

calibration purposes. In addition the highpass filter may be enabled separately on the left and right

channels (see Table 11).

WM8750CLSEFL/R 데이터시트(PDF) 22 Page - Wolfson Microelectronics plc

WM8750CLSEFL/R 데이터시트(HTML) 22 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65

데이터시트 다운로드

링크 URL