RK-WI.232FHSS-25-FCC-R datasheet(58/67 Pages) RADIOMETRIX

58 / 67 page

WI.232FHSS-25-R/ WI.232FHSS-250-R DATASHEET

Revision 1.1.0

default configuration when power is applied to the module. During normal operation, the volatile registers

are used to control the module.

Placing the module in the command mode allows these registers to be programmed. Byte values in

excess of 127 (0x80 or greater) must be changed into a two-byte escape sequence of the format: 0xFE,

[value - 128]. For example, the value 0x83 becomes 0xFE, 0x03. The following function will prefix a 0xFF

header and size specifier to a command sequence and create escape sequences as needed. It is

assumed that *src is populated with either the register number to read (one byte, pass 1 into src_len) or

the register number and value to write (two bytes, pass 2 into src_len). It is also assumed that the *dest

buffer has enough space for the two header characters plus, the encoded command, and the null

terminator.

int EscapeString(char *src, char src_len, char *dest)

{

// The following function copies and encodes the first

// src_len characters from *src into *dest.

This

// encoding is necessary for Wi.232 command formats.

// The resulting string is null terminated.

The size

// of this string is the function return value.

// ---------------------------------------------------

char src_idx, dest_idx;

// Save space for the command header and size bytes

// ------------------------------------------------

dest_idx = 2;

// Loop through source string and copy/encode

// ------------------------------------------

for (src_idx = 0; src_idx < src_len; src_idx++)

{

if (src[src_idx] > 127)

{

dest[dest_idx++] = 0xFE;

}/*if*/

dest[dest_idx++] = (src[src_idx] & 0x7F);

}/*for*/

// Add null terminator

// -------------------

dest[dest_idx] = 0;

// Add command header

// ------------------

dest[0] = 0xFF;

dest[1] = dest_idx – 2;

// Return escape string size

// -------------------------

return dest_idx;

}

Figure 16: Command Conversion Code

5.4. Writing to Registers

Writing to a volatile register is nearly instantaneous. Writing to a non-volatile register, however, typically

takes 16 ms. Because the packet size can vary based on the need for encoding, there are two possible

packet structures. The following tables show the byte sequences for writing a register in each case.

RK-Wi.232FHSS-25-FCC-R 데이터시트(PDF) 58 Page - Radiometrix Ltd

RK-Wi.232FHSS-25-FCC-R 데이터시트(HTML) 58 Page - Radiometrix Ltd

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67

데이터시트 다운로드

링크 URL