| 전자부품 데이터시트 검색엔진 |
|
MTS62C19A 데이터시트(PDF) 7 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
MTS62C19A 데이터시트(HTML) 7 Page - Microchip Technology |
|
7 / 20 page ![]() 2010-2013 Microchip Technology Inc. DS22260C-page 7 MTS62C19A 2.1 Output Stage (OUT1A, OUT2A, OUT1B, OUT2B) Output connection to “A” side and “B” side of motor windings. 2.2 Current Sense Input (SENSE1, SENSE2) Connection to lower sources of output stage for insertion of current sense resistor. 2.3 Current Sense Comparator Input (COMPIN1, COMPIN2) Current sense comparator input. 2.4 Ground Terminal (GND) Logic supply ground. Only the driver current flows out of this pin; there is no high current. Minimize voltage drops between this pin and the logic inputs. 2.5 Current Detection Selection (I01, I02, I11, I12) Comparator input for current threshold detection. The voltage across the sense resistor is fed back to this input through the low-pass filter RcCc. The power tran- sistors are disabled when the sense voltage exceeds the reference voltage of the selected comparator. When this occurs, the current decays for a time set by RtCt (TOFF = 1.1 RtCt). 2.6 Current Flow Direction Selection (PHASE1, PHASE2) Logic input to select the direction of the current flow through the load. A “HIGH” logic signal level causes load current to flow from OUTxA to OUTxB. A “LOW” logic level causes load current to flow from OUTxB to OUTxA. 2.7 Current Sense Reference (VREF1, VREF2) Reference voltage for current sense comparator. Determines the level of output current detection together with sensing resistor and inputs I0x, I1x. 2.8 Output Stage OFF Time (RC1, RC2) A parallel RtCt network connected to this pin sets the OFF time of the power transistors. The monostable pulse generator is triggered by the output of the current sense comparator. 2.9 Logic Supply Voltage (VLOGIC) Connect VLOGIC to the logic source voltage. Decouple the supply with a 0.1 µF ceramic capacitor mounted close to the VLOGIC and GND terminals. 2.10 Load Supply Voltage (VLOAD) Connect VLOAD to the motor positive voltage supply. The motor current is supplied through this pin and the selected output transistors. |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |