M51995AFP datasheet(37/43 Pages) RENESAS

37 / 43 page

M51995AP/AFP

REJ03D0835-0300 Rev.3.00 Jun 06, 2008

Page 35 of 40

However, the M51995A will non-operate and operate intermittently, as the VCC voltage rises in accordance with

the decrease of ICC current.

The fly back system has the constant output power characteristics as shown in figure 35 when the peak primary

current and the operating frequency are constant.

To control the increase of DC output current, the operating frequency is decreased using the characteristics of

VF terminal when the over current limiting function begins to operate.

The voltage which mode by dividing the VCC is applied to VF terminal as shown in figure 36, as the induced

third winding voltage depends on the DC output voltage of SMPS.

15 k

Ω or less is recommended for R

2 in figure 36, it is noticed that the current flows through R1 and R2 will

superpose on the ICC(START) current.

If the R1 is connected to CVCC2 in figure 25, the current flows through R1 and R2 is independent of the ICC(START).

(3) Application circuit to keep the non-operating condition when over load current condition will continue for

specified duration

The CT terminal voltage will begin to rise and the capacitor connected to CT terminal will be charged-up, if the

current limiting function starts, and VF terminal voltage decreases below VTHTIME (∼ 3 V).

If the charged-up CT terminal voltage is applied to OVP terminal through the level-shifter consisted of buffer

transistor and resistor, it makes type M51995A keep non-operating condition.

VCC

OVP

M51995A

Figure 37 Application Circuit Diagram to Keep the Non-Operating Condition when Over Load Current

Condition will Continue for Specified Duration

Output Circuit

1. The output terminal characteristics at the VCC voltage lower than the “Operation-stop” voltage

The output terminal has the current sink ability even though the VCC voltage lower than the “Operation-stop”

voltage or VCC(STOP) (It means that the terminal is “Output low state” and please refer characteristics of output low

voltage versus sink current.)

This characteristics has the merit not to damage the MOS FET at the stop of operation when the VCC voltage

decreases lower than the voltage of VCC (STOP), as the gate charge of MOS FET, which shows the capacitive load

characteristics to the output terminal, is drawn out rapidly.

The output terminal has the draw-out ability above the VCC voltage of 2 V, however, lower than the 2 V, it loses the

ability and the output terminal potential may rise due to the leakage current.

In this case, it is recommended to connect the resistor of 100 k

Ω between gate and source of MOS FET as shown in

figure 38.

M51995A

VOUT

To main

transformer

RCLM

100 k

Ω

Figure 38 Circuit Diagram to Prevent the MOS FET Gate Potential Rising

M51995AFP 데이터시트(PDF) 37 Page - Renesas Technology Corp

M51995AFP 데이터시트(HTML) 37 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

데이터시트 다운로드

링크 URL