W25Q40BLSVIP datasheet(34/74 Pages) WINBOND

34 / 74 page

W25Q40BL

- 34 -

7.2.17 Octal Word Read Quad I/O (E3h)

The Octal Word Read Quad I/O (E3h) instruction is similar to the Fast Read Quad I/O (EBh) instruction

except that the lower four Address bits (A0, A1, A2, A3) must equal 0. As a result, the dummy clocks are

not required, which further reduces the instruction overhead allowing even faster random access for code

execution (XIP). The Quad Enable bit (QE) of Status Register-2 must be set to enable the Octal Word

Read Quad I/O Instruction.

Octal Word Read Quad I/O with “Continuous Read Mode”

The Octal Word Read Quad I/O instruction can further reduce instruction overhead through setting the

“Continuous Read Mode” bits (M7-0) after the input Address bits (A23-0), as shown in figure 16a. The

upper nibble of the (M7-4) controls the length of the next Octal Word Read Quad I/O instruction through

the inclusion or exclusion of the first byte instruction code. The lower nibble bits of the (M3-0) are don’t

care (“x”). However, the IO pins should be high-impedance prior to the falling edge of the first data out

clock.

If the “Continuous Read Mode” bits M5-4 = (1,0), then the next Fast Read Quad I/O instruction (after /CS

is raised and then lowered) does not require the E3h instruction code, as shown in figure 16b. This

reduces the instruction sequence by eight clocks and allows the Read address to be immediately entered

after /CS is asserted low. If the “Continuous Read Mode” bits M5-4 do not equal to (1,0), the next

instruction (after /CS is raised and then lowered) requires the first byte instruction code, thus returning to

normal operation. A “Continuous Read Mode” Reset instruction can also be used to reset (M7-0) before

issuing normal instructions (See 7.2.20 for detail descriptions).

Figure 16a. Octal Word Read Quad I/O Instruction Sequence (Initial instruction or previous M5-4

≠ 10)

Instruction (E3h)

Byte 1

Byte 2

Byte 3

Byte 4

Instruction (E3h)

Byte 1

Byte 2

Byte 3

Byte 4

W25Q40BLSVIP 데이터시트(PDF) 34 Page - Winbond