QB-RL78L1C In-Circuit Emulator

CHAPTER 2

SETUP PROCEDURE

R20UT2703EJ0200

Rev.2.00

Page 27 of 42

Jan 31, 2014

Probe holder

2.4

Connecting QB-RL78L1C to Target System

If connecting the emulation probe (QB-144-EP-02S), connect it to the QB-RL78L1C and the target system by the

following procedure.

(a) Connect the QB-RL78L1C to the probe.

Connect the emulation probe to the QB-RL78L1C, as shown below.

Insert CN1, CN2 and CN3 of the probe into TCN1, TCN2 and TCN3 of the QB-RL78L1C.

Insert the probe holder into QB-RL78L1C as below.

Figure 2-5.

Connect the QB-RL78L1C to the probe

(b) Connection of emulation probe GND wire

There are three GND wires in the emulation probe.

Connect them to the QB-RL78L1C and target system.

<1> Fasten the GND wire on the QB-RL78L1C side of the emulation probe to the nut on the bottom of

the QB-RL78L1C using a #0 or #1 Phillips precision screwdriver (connection of B to A in Figure 2-6).

<2> Next insert the connector on the top of the emulation probe into the connector at the opening on

the bottom of the QB-RL78L1C from below being careful of the insertion direction (connection of C in

Figure 2-6 to QB-RL78L1C).