• North America Tel: 800.366.2266 / Fax: 978.366.2266

• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300

• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298

Visit www.macomtech.com for additional data sheets and product information.

M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make

changes to the product(s) or information contained herein without notice.

4

High Dynamic Range Low Noise Amplifier

1400 - 2000 MHz

Rev. V1

MAAMSS0045

ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions

is considering for development. Performance is based on target specifications, simulated results,

and/or prototype measurements. Commitment to develop is not guaranteed.

PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology

Solutions has under development. Performance is based on engineering tests. Specifications are

typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.

Commitment to produce in volume is not guaranteed.

Cross Section View

The PCB dielectric between RF traces and RF ground

layers should be chosen to reduce RF discontinuities

between 50 Ω lines and package pins.

M/A-COM

recommends

an

FR-4

dielectric

thickness

of .008” (0.20 mm) yielding a 50 Ω lines width of

0.015” (0.38 mm). The recommended RF metalization

is 1 ounce copper.

The MAAMSS0045SMB Designer’s Kit allows for immediate evaluation of M/A-COM’s MAAMSS0045. The

Designer’s Kit includes an MAAMSS0045 mounted on an evaluation board and five loose MAAMSS0045’s. The

evaluation board consists of the recommended external surface mount circuitry, RF connectors, and a DC

multi-pin connector, all mounted to a multi-layer FR-4 PCB.

The MAAMSS0045SMB evaluation PCB is

illustrated below with all functional ports labeled.

Designer’s Kit MAAMSS0045SMB

Evaluation PCB & RF Connector Losses

Port Reference

Approximate RF Loss

RF In

0.15 dB @ 1785 MHz

RF Out

0.15 dB @ 1785 MHz

The DC connector on the Designer’s Kit PCB allows convenient

DC line access. This is accomplished by the one or more of the

following methods.

1.

A mating female multi-pin connector (Newark Electronics

Stock # 46F-4658, not included).

2.

Wires soldered to the necessary pins (not included).

3.

Clip leads (not included).

MAAMSS0045 Evaluation Board

Recommended PCB Configuration

Layout View