| 전자부품 데이터시트 검색엔진 |
|
L6207Q 데이터시트(PDF) 16 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
L6207Q 데이터시트(HTML) 16 Page - STMicroelectronics |
|
16 / 27 page ![]() Circuit description L6207Q 16/27 DocID018993 Rev 3 When the monostable times out, the lower power MOSFET is turned on again after some delay set by the deadtime to prevent cross conduction. Figure 13. Slow decay mode output stage configurations 5.5 Non-dissipative overcurrent detection and protection The L6207Q device integrates an overcurrent detection circuit (OCD). With this internal overcurrent detection, the external current sense resistor normally used and its associated power dissipation are eliminated. Figure 14 shows a simplified schematic of the overcurrent detection circuit for bridge A. Bridge B is provided by an analogous circuit. To implement the overcurrent detection, a sensing element that delivers a small but precise fraction of the output current is implemented with each high-side power MOSFET. Since this current is a small fraction of the output current there is very little additional power dissipation. This current is compared with an internal reference current IREF. When the output current reaches the detection threshold (typically 5.6 A) the OCD comparator signals a fault condition. When a fault condition is detected, an internal open drain MOSFET with a pull-down capability of 4 mA connected to the EN pin is turned on. Figure 15 shows the OCD operation. By using an external R-C on the EN pin, as shown in Figure 14, the OFF time before recovering normal operation can be easily programmed by means of the accurate thresholds of the logic inputs. The disable time tDISABLE before recovering normal operation can be easily programmed by means of the accurate thresholds of the logic inputs. It is affected by both CEN and REN values and its magnitude is reported in Figure 16. The delay time tDELAY before turning off the bridge when an overcurrent has been detected depends only on the CEN value. Its magnitude is reported in Figure 17. CEN is also used for providing immunity to pin EN against fast transient noises. Therefore the value of CEN should be chosen as big as possible according to the maximum tolerable delay time and the REN value should be chosen according to the desired disable time. The resistor REN should be chosen in the range from 2.2 k to 180 k. Recommended values for REN and CEN are respectively 100 k and 5.6 nF which allow to obtain 200 µs disable time. |
|
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |