Operation of the STEVAL-TLL005V1 demonstration board

UM0582

12/24

Doc ID 14969 Rev 1

●

Torch mode - to observe this mode, perform the following steps:

–

Configure the torch mode current by moving the slider in the torch area of the GUI

(refer to Figure 10).

–

Insert the torch mode command by pressing the "Add/Insert torch" button on the

GUI.

–

Press the "Run sequence" button on the GUI to see the torch LED on the board

turn on.

–

This torch lasts for 2 seconds, then goes off automatically.

–

To abort the torch before the process is complete, press the "STOP" button on

GUI.

●

Auxiliary LED mode - the functionality of the red auxiliary LED on the daughterboard

can be configured through the GUI. The steps required to observe the auxiliary LED

mode of the STCF03 are as follows:

1.

Configure the auxiliary LED time and current through the GUI (current and time should

not be zero). See Figure 11.

2.

Insert the auxiliary LED command by pressing the "Add/Insert AUX LED" button on the

GUI.

3.

Press the "Run sequence" button on the GUI to observe the auxiliary LED on the

board. The glow duration of the LED is equal to the time configured using the time

slider in the "AUX LED" section.

Figure 10.

Slider to configure torch