Operation of the STEVAL-TLL005V1 demonstration board

UM0582

16/24

Doc ID 14969 Rev 1

●

Auxiliary LED mode - this mode shows the auxiliary LED control feature of the STCF03.

To configure auxiliary LED control, perform the following steps:

–

Go to ready mode. The "Aux LED" checkbox becomes enabled.

–

Check the "Aux LED" checkbox, as shown in Figure 17.

–

Adjust the current value.

–

Adjust the timer (see Figure 18).

–

Click on the "Write data to the chip" button.

Figure 16.

Torch operation mode selection in the register controller GUI

Figure 17.

Auxiliary operation mode selection in the register controller GUI