UPD703003 datasheet(15/82 Pages) NEC

15 / 82 page

µPD703003

Data Sheet U12261EJ2V1DS00

3.1.9 Serial interface (SIO)

Four channels are comprised of two kinds of serial interfaces: an asynchronous serial interface (UART) and a clock-

synchronized serial interface (CSI). Two of these four channels are switchable between the UART and CSI and the

other two channels are fixed as CSI.

For UART, data is transferred via the TXD and RXD pins. The baud rate is determined by the on-chip baud rate

generator. For CSI, data is transferred via the SO, SI, and SCK pins. The baud rate can be determined by the on-

chip baud rate generator or it can be supplied from an external source.

One of the two CSI-fixed channels is used as the serial clock output, and serial output is sent via an N-ch open

drain output.

3.1.10 Pulse width modulation (PWM)

There are two channels of selectable 8/9/10/12-bit resolution PWM signal outputs. When a low pass filter is

externally connected, PWM output can be used as D/A converter output. This is suitable for actuator control

applications, such as in motors.

3.1.11 A/D converter (ADC)

This is a high-speed, high-resolution 10-bit A/D converter that includes eight analog input pins. It converts using

the sequential conversion method.

3.1.12 D/A converter (DAC)

This is an 8-bit resolution D/A converter that includes two channels. It converts using the R-2R conversion method.

UPD703003 데이터시트(PDF) 15 Page - NEC