UM0844 datasheet(25/43 Pages) STMICROELECTRONICS

25 / 43 page

UM0844

The SPEAr Linux Support Package (LSP2.3)

Doc ID 16544 Rev 3

25/43

3.5

How to install the SPEAr Linux Support Package (LSP2.3)

The SPEAr Linux Support Package (LSP2.3) is needed to develop software running on a

SPEAr target boards when embedded Linux is to be used as the target’s operating system.

The SPEAr Linux Support Package (LSP2.3) is not needed in order to use the software pre-

flashed on SPEAr boards or to update the Flash memory with default predefined contents.

Note:

The SPEAr Linux Support Package (LSP2.3) software must be installed on a Linux PC.

Windows® PCs are not supported.

3.5.1

First-time installation

To install the SPEAr Linux Support Package (LSP2.3) for the first time, perform the following

steps:

Read the software licence agreement provided in Appendix A: Software license

agreement on page 38 of this manual.

Note:

This Software License Agreement ("Agreement") is displayed for you to read prior to

downloading and using the Licensed Software. If you choose not to agree with these

provisions, do not download or install the enclosed Licensed Software and the related

documentation and design tools. By using the Licensed Software, you are agreeing to be

bound by the terms and conditions of this Agreement. Do not use the Licensed Software

until you have read and agreed to the following terms and conditions. The use of the

Licensed Software implies automatically the acceptance of the following terms and

conditions.

Connect to the www.st.com and navigate to the product pages for embedded

microprocessors. The link for downloading the SPEAr Linux Support Package

(LSP2.3) can be found by navigating to the web page containing the literature and other

resources for the related SPEAr device (product pages).

Note:

To download the file, you have to use a browser running on the Linux development PC.

Click on link below to download the initial installation script to your Linux PC: install

script download:

ftp://stlinux.com/pub/stlinux/2.3/install

Run the downloaded script on your Linux PC as follows: ./install all-arm-spear

This procedure automatically starts the overall download and installation of the

required software components (remotely available as RPM packages). The entire

procedure takes several minutes, depending on the network speed. The distribution is

installed by default under path /opt/STM.

When the installation is completed, configure the Linux shell environment as follows:

export PATH=$PATH:.:/opt/STM/STLinux-2.3/devkit/arm/bin:/opt/STM/STLinux-

2.3/host/bin

export CROSS_COMPILE=arm-linux-

In order to preserve this configuration, the same commands should be also be put in a

bash shell initialization file.

UM0844 데이터시트(PDF) 25 Page - STMicroelectronics

UM0844 데이터시트(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

데이터시트 다운로드

링크 URL