UM0851 datasheet(96/245 Pages) STMICROELECTRONICS

96 / 245 page

Communication device drivers

UM0851

96/245

Doc ID 16604 Rev 2

int (*suspend)(struct mmc_card *, pm_message_t);

int (*resume)(struct mmc_card *);

};

During registration, the probe function of the card driver will be called and a pointer to

card structure will be passed. You must use this pointer for any further communication

with host driver.

●

Claim host:

The card driver must claim host in order to do any transfers with the card using the

host controller. This can be done using the following function call:

/* host: MMC host to claim. It can be found in card structure (card->host)*/

void mmc_claim_host(struct mmc_host *host);

●

Send command:

This function starts a new MMC command for a host, and waits for the command to

complete. This will not exchange any data with the card. Only configuration related

commands are sent here. It returns any error that occurred while the command was

executing, without attempting to parse the response. This function is used to configure

the SDIO host controller. Please use the struct mmc_command in the

include/linux/mmc/core.h file to see all the configuration options.

/* host: MMC host to start command

cmd: MMC command to start

retries: maximum number of retries */

int mmc_wait_for_cmd(struct mmc_host *host, struct mmc_command *cmd, int retries);

●

Send request:

This function starts a new MMC custom command request for a host, and waits for the

command to be completed. It sends data using data commands. It does not attempt to

parse the response. You can use it for any kind of data transfer with the SDIO/SD/MMC

card using the SDIO host controller.

/* host: MMC host to start command

mrq: MMC request to start */

void mmc_wait_for_req(struct mmc_host *host, struct mmc_request *mrq);

struct mmc_request {

struct mmc_command

*cmd;

struct mmc_data *data;

struct mmc_command *stop;

void

*done_data;/* completion data */

void

(*done)(struct mmc_request *);/* completion function */

};

●

Set timeout for data command:

This function sets the timeout for a data command. It computes the data timeout

parameters according to the correct algorithm related to the card type.

/* data: data phase for command

card: MMC card associated with the data transfer */

void mmc_set_data_timeout(struct mmc_data *data, const struct mmc_card *card);

●

Set clock:

This function sets the host clock to the highest possible frequency that is below "hz".

UM0851 데이터시트(PDF) 96 Page - STMicroelectronics

UM0851 데이터시트(HTML) 96 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL