| 전자부품 데이터시트 검색엔진 |
|
UM0851 데이터시트(PDF) 105 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
UM0851 데이터시트(HTML) 105 Page - STMicroelectronics |
|
105 / 245 page ![]() UM0851 Communication device drivers Doc ID 16604 Rev 2 105/245 4.9 CAN driver CAN is a message based protocol designed specifically for automotive applications, but now also used in other areas such as industrial automation and medical equipment. This section describes the driver for the SPEAr320 CAN controller. 4.9.1 Hardware overview Note: Available only on SPEAr320 SPEAr320 provides two independent CAN bus interfaces fully compliant to CAN 2.0 protocol specifications (both Part A and Part B) within its standard customization. The main features provided by the CAN IP are listed below: ● Bit rates up to 1 MBit/s ● 32 Message objects ● Each Message object has its own identifier mask ● Programmable FIFO mode (concatenation of message objects) ● Maskable interrupt ● Disabled automatic retransmission mode for time triggered CAN applications ● Programmable loop-back mode for self-test operation CAN IPs in SPEAr support the following test modes. The test mode is entered by setting bit test in the CAN control register to one. In test mode, the bits Tx1, Tx0, LBack, Silent and Basic in the test register are writable: ● Silent mode – In this mode, the IP is able to receive valid data frames and valid remote frames, but it sends only recessive bits on the CAN bus and it cannot start a transmission. – It can be used to analyze the traffic on a CAN bus without affecting it by the transmission of dominant bits (acknowledge bits, error frames). ● Loopback mode – In loop back mode, the CAN core treats its own transmitted messages as received messages and stores them (if they pass acceptance filtering) into a receive buffer. ● Loopback combined with silent mode This mode can be used for a "hot self test", meaning the CAN IP can be tested without affecting a running CAN system connected to the pins CAN_TX and CAN_RX. ● Basic mode In this mode the CAN IP runs without the Message RAM. Note: For further details please refer to SPEAr320 user manual |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |