PIC17C752-08SLASHCL datasheet(165/328 Pages) MICROCHIP

165 / 328 page

DS30289A-page 165

PIC17C7XX

15.2.14 STOP CONDITION TIMING

A stop bit is asserted on the SDA pin at the end of a

receive/transmit by setting the Stop Sequence Enable

bit PEN (SSPCON2<2>). At the end of a receive/trans-

mit the SCL line is held low after the falling edge of the

ninth clock. When the PEN bit is set, the master will

assert the SDA line low . When the SDA line is sam-

pled low, the baud rate generator is reloaded and

counts down to 0.

When the baud rate generator

times out, the SCL pin will be brought high, and one

TBRG (baud rate generator rollover count) later, the

SDA pin will be de-asserted. When the SDA pin is

sampled high while SCL is high, the P bit (SSP-

STAT<4>) is set. A TBRG later the PEN bit is cleared

and the SSPIF bit is set. (Figure 15-34)

Whenever the ﬁrmware decides to take control of the

bus, it will ﬁrst determine if the bus is busy by checking

the S and P bits in the SSPSTAT register. If the bus is

busy, then the CPU can be interrupted (notiﬁed) when

a Stop bit is detected (i.e. bus is free).

15.2.14.1 WCOL STATUS FLAG

If the user writes the SSPBUF when a STOP

sequence is in progress, then WCOL is set and the

contents of the buffer are unchanged (the write doesn’t

occur).

FIGURE 15-34: STOP CONDITION RECEIVE OR TRANSMIT MODE

SCL

SDA

SDA asserted low before rising edge of clock

Write to SSPCON2

Set PEN

Falling edge of

SCL = 1 for T

BRG, followed by SDA = 1 for TBRG

9th clock

SCL brought high after T

BRG

Note: T

BRG = one baud rate generator period.

BRG

after SDA sampled high. P bit (SSPSTAT<4>) is set

BRG

to setup stop condition.

ACK

BRG

PEN bit (SSPCON2<2>) is cleared by

hardware and the SSPIF bit is set

PIC17C752-08/CL 데이터시트(PDF) 165 Page - Microchip Technology

PIC17C752-08/CL 데이터시트(HTML) 165 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL