| 전자부품 데이터시트 검색엔진 |
|
RF63 데이터시트(PDF) 43 Page - List of Unclassifed Manufacturers |
|
|
|||||||||||||||||||||||||||||
RF63 데이터시트(HTML) 43 Page - List of Unclassifed Manufacturers |
|
43 / 91 page ![]() ADVANCED COMMUNICATIONS & SENSING Page 43 of 91 RF63 Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com uC 5.3.5. uC Connections RF63 DATA IRQ_0 IRQ_1 (DCLK) NSS_CONFIG SCK MOSI MISO Figure 37: uC Connections in Continuous Mode Note that some connections may not be needed depending on the application: • IRQ_0: if Sync and RSSI interrupts are not used. In this case, leave floating. • IRQ_1: if the chip is never used in Tx FSK mode (DCLK connection is not compulsory in Rx and Tx OOK modes). In this case, leave floating. • MISO: if no read register access is needed. In this case, pull-up to VDD through a 100 k Ω resistor. In addition, NSS_DATA pin (unused in continuous mode) should be pulled-up to VDD through a 100 k Ω resistor. Please refer to Table 13 for RF63 ‟s pins configuration 5.3.6. Continuous Mode Example • Configure all data processing related registers listed below appropriately. In this example we assume that both Bit synchronizer and Sync word recognition are on. Table 19: Relevant Configuration Registers in Continuous Mode (data processing related only) Tx Rx Description MCParam Data_mode_x X X Defines data operation mode (- Continuous) IRQParam Rx_stby_irq_0 X Defines IRQ_0 source in Rx mode RXParam Sync_on X Enables Sync word recognition Sync_size X Defines Sync word size Sync_tol X Defines the error tolerance on Sync word recognition SYNCParam Sync_value X Defines Sync word value Tx Mode: • Go to Tx mode (and wait for Tx to be ready, see Figure 50) • Send all packet ‟s bits on DATA pin synchronously with DCLK signal provided on IRQ_1 • Go to Sleep mode Rx Mode: • Program Rx interrupts: IRQ_0 mapped to Sync (Rx_stby_irq_0= ”00”) and IRQ_1 mapped to DCLK (Bit synchronizer enabled) • Go to Rx mode (note that Rx is not ready immediately, see Figure 49) • Wait for Sync interrupt • Get all packet bits on DATA pin synchronously with DCLK signal provided on IRQ_1 • Go to Sleep mode |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |