RF65 datasheet(29/72 Pages) ETC2

29 / 72 page

Page 29

RF65

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

ADVANCED COMMUNICATIONS & SENSING

DATASHEET

3.4.18. Temperature Sensor

When temperature is measured, the receiver ADC is used to digitize the sensor response. Most receiver blocks are

disabled, and temperature measurement can only be triggered in Standby or Frequency Synthesizer modes.

The response of the temperature sensor is -1°C / Lsb. A CMOS temperature sensor is not accurate by nature, therefore it

should be calibrated at ambient temperature for precise temperature readings.

TempValue

-1

°C/Lsb

TempValue(t)

TempValue(t)-1

Returns 150d (typ.)

Needs calibration

-40

°C

t t+1

Ambient

+85

°C

Figure 13. Temperature Sensor Response

It takes less than 100 microseconds for the RF65 to evaluate the temperature (from setting TempMeasStart to 1 to

TempMeasRunning reset).

3.4.19. Timeout Function

The RF65 includes a Timeout function, which allows it to automatically shut-down the receiver after a receive sequence

and therefore save energy.



Timeout interrupt is generated TimeoutRxStart x 8 x Tbit after switching to RX mode if RssiThreshold flag does not raise

within this time frame



Timeout interrupt is generated TimeoutRssiThresh x 8 x Tbit after RssiThreshold flag has been raised.

This timeout interrupt can be used to warn the companion processor to shut down the receiver and return to a lower power

mode.

RF65 데이터시트(PDF) 29 Page - List of Unclassifed Manufacturers