GP2010 datasheet(6/24 Pages) MITEL

6 / 24 page

GP2010

PIN DESCRIPTIONS

All VEE and VCC/VDD pins should be connected to ensure reliable operation

Pin No.

Signal Name

Input/Output

Description

IFOutput

Output

IF Test output.

Connected to output of Stage 3 prior to the A to D converter.

A series 1k

Ω resistor is incorporated for buffering purposes.

PLL Filt1

Output

PLL Filter 1.

Connected to the bias network within the on-chip VCO. An

external PLL loop filter network should be connected between

this pin and PLL Filt 2 (see below).

PLL Filt2

Output

PLL Filter 2.

Connected to the varactor diodes within the on-chip VCO. An

external PLL loop filter network should be connected between

this pin and PLL Filt 1 (see above).

4,6

VEE (OSC)

Input

Negative supply to the on-chip VCO. (See Note 1)

5VCC (OSC)

Input

Positive supply to the on-chip VCO.

7VEE (REG)

Input

Negative supply to the VCO regulator.

This must be connected to GND.

PRef

Input

Power-on Reset Reference input.

An on-chip comparator produces a logic HI when the PRef

input voltage exceeds +1.21V. (Nom) (See Page 3).

PReset

Output

Power-on Reset Output.

A TTL compatible output controlled by the Power-on reset

comparator (See above). This output remains active even

when the chip is powered down. (See pin 17 - PDn).

VEE (IO)

Input

Negative supply to the Digital Interface. (See Note 2)

CLK

Input

Sample Clock input from the correlator chip.

A TTL compatible input (which operates at 5.714MHz if used

with GP2021 correlator device) used to clock the MAG & SIGN

output latches, on the rising edge of the CLK signal.

MAG

Output

Magnitude bit data output.

A TTL compatible signal, representing the

magnitude of the

mixed down IF signal. Derived from the on-chip 2-bit A to D

converter, synchronised to the CLK input clock signal.

SIGN

Output

Sign bit data output.

A TTL compatible signal, representing the

polarity of the mixed

down IF signal. Derived from the on-chip 2-bit A to D converter,

synchronised to the CLK input clock signal.

OPClk-

Output

40MHz Clock output - inverse phase.

One side of a balanced differential output clock, with opposite

polarity to Pin 15 - OPClk+. Used to drive a master-clock signal

within the correlator chip.

OPClk+

Output

40MHz Clock output - true phase.

Other side of a balanced differential output clock set, with

opposite polarity to Pin 14 - OPClk-. Used to drive a master-

clock signal within the correlator chip.

VDD (IO)

Input

Positive supply to the Digital Interface. (See Note 2)

GP2010 데이터시트(PDF) 6 Page - Mitel Networks Corporation

GP2010 데이터시트(HTML) 6 Page - Mitel Networks Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

데이터시트 다운로드

링크 URL