USB3320 datasheet(62/70 Pages) MICROCHIP

62 / 70 page

USB3320

DS00001792B-page 62

 2014-2015 Microchip Technology Inc.

8.2

Reference Designs

Microchip has generated reference designs for connecting the USB3320 to SOCs with a ULPI port. Please contact the

Microchip sales office for more details.

8.3

ESD Performance

The USB3320 is protected from ESD strikes. By eliminating the requirement for external ESD protection devices, board

space is conserved, and the board manufacturer is enabled to reduce cost. The advanced ESD structures integrated

into the USB3320 protect the device whether or not it is powered up.

8.3.1

HUMAN BODY MODEL (HBM) PERFORMANCE

HBM testing verifies the ability to withstand the ESD strikes like those that occur during handling and manufacturing,

and is done without power applied to the IC. To pass the test, the device must have no change in operation or perfor-

mance due to the event. All pins on the USB3320 except the REFCLK, SPK_L, and SPK_R pins provide ±8kV HBM

protection, as shown in Table 4-10.

8.3.2

EN/IEC 61000-4-2 PERFORMANCE

The EN/IEC 61000-4-2 ESD specification is an international standard that addresses system-level immunity to ESD

strikes while the end equipment is operational. In contrast, the HBM ESD tests are performed at the device level with

the device powered down.

Microchip contracts with Independent laboratories to test the USB3320 to EN/IEC 61000-4-2 in a working system.

Reports are available upon request. Please contact your Microchip representative, and request information on 3rd party

ESD test results. The reports show that systems designed with the USB3320 can safely provide the ESD performance

shown in Table 4-10 without additional board level protection.

In addition to defining the ESD tests, EN/IEC 61000-4-2 also categorizes the impact to equipment operation when the

strike occurs (ESD Result Classification). The USB3320 maintains an ESD Result Classification 1 or 2 when subjected

to an EN/IEC 61000-4-2 (level 4) ESD strike.

Both air discharge and contact discharge test techniques for applying stress conditions are defined by the EN/IEC

61000-4-2 ESD document.

8.3.3

AIR DISCHARGE

To perform this test, a charged electrode is moved close to the system being tested until a spark is generated. This test

is difficult to reproduce because the discharge is influenced by such factors as humidity, the speed of approach of the

electrode, and construction of the test equipment.

8.3.4

CONTACT DISCHARGE

The uncharged electrode first contacts the USB connector to prepare this test, and then the probe tip is energized. This

yields more repeatable results, and is the preferred test method. The independent test laboratories contracted by Micro-

chip provide test results for both types of discharge methods.

USB3320 데이터시트(PDF) 62 Page - Microchip Technology

USB3320 데이터시트(HTML) 62 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70

데이터시트 다운로드

링크 URL