LSM303AGRTR datasheet(40/68 Pages) STMICROELECTRONICS

부품명	LSM303AGRTR

상세설명	Ultra-compact high-performance eCompass module: ultra-low-power 3D accelerometer and 3D magnetometer

PDF	68 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

40 / 68 page

Digital interfaces

LSM303AGR

40/68

DocID027765 Rev 5

6.2.2

Accelerometer SPI read in 3-wire mode

3-wire mode is entered by setting the CTRL_REG4_A (23h) (SPI_ENABLE) bit equal ‘1’

(SPI serial interface read enable).

Figure 13. Accelerometer SPI read protocol in 3-wire mode

The SPI read command is performed with 16 clock pulses:

bit 0: READ bit. The value is 1.

bit 1: MS bit. When 0, does not increment the address; when 1, increments the address in

multiple reads.

bit 2-7: address AD(5:0). This is the address field of the indexed register.

bit 8-15: data DO(7:0) (read mode). This is the data that is read from the device (MSb first).

A multiple read command is also available in 3-wire mode.

6.2.3

Magnetometer SPI write

Figure 14. Magnetometer SPI write protocol

The SPI write command is performed with 16 clock pulses. The multiple byte write

command is performed by adding blocks of 8 clock pulses to the previous one.

bit 0: WRITE bit. The value is 0.

bit 1-7: address AD(6:0). This is the address field of the indexed register.

bit 8-15: data DI(7:0) (write mode). This is the data that is written inside the device (MSb

first).

bit 16-... : data DI(...-8). Further data in multiple byte writes.

SPC

SDI

D I7D I6

D I5D I4

DI3DI2

DI1DI0

AD5 AD 4 AD 3 AD2 AD 1 AD0

AD6

LSM303AGRTR 데이터시트(PDF) 40 Page - STMicroelectronics