M95M01-DWMN3TP datasheet(24/40 Pages) STMICROELECTRONICS

부품명	M95M01-DWMN3TP

상세설명	Automotive 1 Mbit serial SPI bus EEPROMs

PDF	40 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

24 / 40 page

Instructions

M95M01-A125 M95M01-A145

24/40

DocID023214 Rev 6

The Read Lock Status instruction is not accepted and not executed if a Write cycle is

currently in progress.

Figure 14. Read Lock Status sequence

4.10

Lock Identification Page (LID)

The Lock Identification Page (LID) command is used to permanently lock the Identification

Page in Read-only mode.

The LID instruction is issued by driving Chip Select (S) low, sending (MSB first) the

instruction code, the address and a data byte on Serial Data input (D), and driving Chip

Select (S) high. In the address sent, A10 must be equal to 1. All other address bits are Don't

Care (it might be easier to define these bits as 0, as shown in Table 7). The data byte sent

must be equal to the binary value xxxx xx1x, where x = Don't Care. The LID instruction is

terminated by driving Chip Select (S) high at a data byte boundary, otherwise, the instruction

is not executed.

Figure 15. Lock ID sequence

M95M01-DWMN3TP 데이터시트(PDF) 24 Page - STMicroelectronics