M08045 datasheet(26/49 Pages) MA-COM

26 / 49 page

Functional Description

M08035, M08045 Data Sheet V1

MACOM

™

080x5-DSH-001

Figure 4-6 illustrates a Serial Write Mode followed by a Serial Read mode. To initiate a Write sequence, xCS goes

low before the falling edge of SCLK. On each falling edge of the clock, the 18 bits consisting of the SB = 1, OP = 0,

ADDR, and DATA, are latched into the input shift register through SI. The rising edge of xCS may occur before or

after the falling edge of SCLK for the last bit. Upon receipt of the last bit, one additional cycle of SCLK is necessary

before DATA transfers from the input shift register to the addressed register.

To initiate a read sequence, xCS goes low before the falling edge of SCLK. On each falling edge of SCLK, the 10

bits consisting of SB = 1, OP = 1, and the 8-bit ADDR are written to the serial input shift register and copied to the

serial output shift register. On the next rising edge after the address LSB, the SB and 8 bits of the DATA are shifted

out. The SB for a Read is always 1.

The 4-wire interface supports multiple consecutive writes. In this case, the address header is not needed and each

additional 8 bits of data will be written into consecutive addresses. If consecutive read/write cycles are being

performed, it is not necessary to insert an extra clock cycle between read/write cycles, however one extra clock

cycle is needed after the last data bit of the last read/write cycle.

Figure 4-5.

Four-wire Interface Word Format

Figure 4-6.

Four-Wire Write Followed by a Read Sequence

SCLK

xCS

...

Address[7:0]

Data[7:0]

...

Tcs

Tdh

Tds

Address[7:0]

...

Tcs

Tch

Tcs

Trdd

M08045 데이터시트(PDF) 26 Page - M/A-COM Technology Solutions, Inc.