CS5530 datasheet(204/241 Pages) NSC

204 / 241 page

www.national.com

204

Revision 4.1

Offset 28h-2Bh

CRC Signature and TFT/TV Configuration Register (R/W)

Reset Value = 00000100h

31:8

24-Bit Video Signature Data (Read Only)

SYNC Override: Drive VSYNC_OUT on FP_VSYNC_OUT and HSYNC_OUT on FP_HSYNC_OUT:

0 = Disable; 1 = Enable.

Invert FP_CLK: 0 = Disable; 1 = Enable. (Applicable for TV not TFT.)

Invert FP_CLK_EVEN: 0 = Disable; 1 = Enable.

4:3

Reserved (Read Only)

Signature Free Run: 0 = Disable; 1 = Enable.

When high, with the signature enabled, the signature generator captures data continuously across multiple frames. This

bit may be set high when the signature is started, then later set low, which causes the signature generation process to

stop at the end of the current frame.

FP_HSYNC_OUT Delay: 0 = Disable; 1 = Enable. (Applicable for TFT not TV.)

When SYNC Override (bit 7) is high, this bit (bit 1) can be set high to delay FP_HSYNC_OUT by an extra two clock

cycles. When the SYNC Override (bit 7) is low, this bit should also be set low.

Signature Enable: 0 = Disable; 1= Enable.

When low the signature register is reset to 000001h and held (no capture). When high, the signature register captures the

pixel data signature with each pixel clock beginning with the next vsync.

Table 4-22. F4BAR+Memory Offset xxh: Video Controller Configuration Registers (Continued)

Bit

Description

CS5530 데이터시트(PDF) 204 Page - National Semiconductor (TI)