| 전자부품 데이터시트 검색엔진 |
|
DP83953 데이터시트(PDF) 20 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
DP83953 데이터시트(HTML) 20 Page - National Semiconductor (TI) |
|
20 / 90 page ![]() 4.0 Functional Description (Continued) 20 www.national.com Figure 5 shows two RIC2As A and B, daisy chained together with RIC2A-A positioned at the top of the chain. If a packet is received at port B1 of RIC2A-B, and then repeated to the other ports in the system (non-secure mode). Figure 6 shows the functional timing diagram for the packet repetition signals. In this example only two ports in the system are shown. In non-secure mode, the other ports also repeat the packet. It also indicates the operation of the RIC2As' state machines in so far as can be seen by observing the Inter-RIC bus. For reference, the repeater's state transitions are shown in terms of the states defined by the IEEE specification. The location of PORT N is also shown. The following section describes the repeater and Inter-RIC bus transitions shown in Figure 6. The repeater activity is stimulated by the data signal received by port B1. The RIC2As in the system are alerted to forthcoming repeater operation by the falling edges on the ACKI and ACKO daisy chain and the ACTN bus signal. Following a defined start up delay the repeater moves to the SEND PREAMBLE state. The RIC2A system utilizes the start up delay to perform port arbitration. When packet transmission begins, the RIC2A system enters the REPEAT state. The expected, for normal packet repetition, sequence of repeater states, SEND PREAMBLE, SEND SFD and SEND DATA are followed, but are not visible at the Inter-RIC bus. They are then merged into a single REPEAT state. Similarly, the WAIT and IDLE states appear as a combined Inter-RIC bus IDLE state. Once a REPEAT operation has begun (e.g. the repeater leaves the IDLE state), it is required to transmit at least 96 bits of data or jam/preamble onto its network segments. If the duration of the received signal from PORT N is shorter than 96 bits, the repeater transitions to the RECEIVE COL- LISION state (described later). This behavior is known as fragment extension. After the packet data has been repeated, including the emptying of the RIC2As' elasticity buffers, the RIC2A per- forms the Tw1 transmit recovery operation. This is per- formed during the WAIT state shown in the repeater state diagram. Figure 5. RIC2A System Topology |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |