CAP1206 datasheet(39/63 Pages) MICROCHIP

39 / 63 page

 2013-2015 Microchip Technology Inc.

DS00001567B-page 39

CAP1206

5.17

Recalibration Configuration Register

The Recalibration Configuration register controls some recalibration routine settings (see Section 4.4, "Sensor Input

Calibration") as well as advanced controls to program the Sensor Input Threshold register settings.

Bit 7 - BUT_LD_TH - Enables setting all Sensor Input Threshold registers by writing to the Sensor Input 1 Threshold

• ‘0’ - Each Sensor Input X Threshold register is updated individually.

• ‘1’ (default) - Writing the Sensor Input 1 Threshold register will automatically overwrite the Sensor Input Threshold

registers for all sensor inputs (Sensor Input Threshold 1 through Sensor Input Threshold 6). The individual Sensor

Input X Threshold registers (Sensor Input 2 Threshold through Sensor Input 6 Threshold) can be individually

updated at any time.

Bit 6 - NO_CLR_INTD - Controls whether the accumulation of intermediate data is cleared if the noise status bit is set.

• ‘0’ (default) - The accumulation of intermediate data is cleared if the noise status bit is set.

• ‘1’ - The accumulation of intermediate data is not cleared if the noise status bit is set.

APPLICATION NOTE: Bits 5 and 6 should both be set to the same value. Either both should be set to ‘0’ or both

should be set to ‘1’.

Bit 5 - NO_CLR_NEG - Controls whether the consecutive negative delta counts counter is cleared if the noise status bit

is set.

‘0’ (default) - The consecutive negative delta counts counter is cleared if the noise status bit is set.

‘1’ - The consecutive negative delta counts counter is not cleared if the noise status bit is set.

Bits 4 - 3 - NEG_DELTA_CNT[1:0] - Determines the number of negative delta counts necessary to trigger a digital reca-

libration (see Section 4.4.2, "Negative Delta Count Recalibration"), as shown in Table 5-30.

Bits 2 - 0 - CAL_CFG[2:0] - Determines the update time and number of samples of the automatic recalibration routine

(see Section 4.4.1, "Automatic Recalibration"). The settings apply to all sensor inputs universally (though individual sen-

sor inputs can be configured to support recalibration - see Section 5.10.1).

TABLE 5-29:

RECALIBRATION CONFIGURATION REGISTERS

Addr

R/W

Default

2Fh

R/W

Recalibration

Configuration

BUT_

LD_TH

NO_CLR

_INTD

NO_CLR

_NEG

NEG_DELTA_

CNT[1:0]

CAL_CFG[2:0]

8Ah

TABLE 5-30:

NEG_DELTA_CNT BIT DECODE

NEG_DELTA_CNT[1:0]

Number of Consecutive Negative Delta Count Values

16 (default)

None (disabled)

CAP1206 데이터시트(PDF) 39 Page - Microchip Technology

CAP1206 데이터시트(HTML) 39 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

데이터시트 다운로드

링크 URL