TMS570LS1114 datasheet(134/169 Pages) TI1

134 / 169 page

N2HET1

N2HET2

IOMMmuxcontrolsignalx

N2HET1[1,3,5,7,9,11]/N2HET2[8,10,12,14,16,18]

N2HET1[1,3,5,7,9,11]

N2HET2[8,10,12,14,16,18]

TMS570LS1114

SPNS188B – OCTOBER 2012 – REVISED FEBRUARY 2015

www.ti.com

Figure 7-12. N2HET Monitoring

7.6.5.2

Output Monitoring using Dual Clock Comparator (DCC)

N2HET1[31] is connected as a clock source for counter 1 in DCC1. This allows the application to measure

the frequency of the pulse-width modulated (PWM) signal on N2HET1[31].

Similarly, N2HET2[0] is connected as a clock source for counter 1 in DCC2. This allows the application to

measure the frequency of the pulse-width modulated (PWM) signal on N2HET2[0].

Both N2HET1[31] and N2HET2[0] can be configured to be internal-only channels. That is, the connection

to the DCC module is made directly from the output of the N2HETx module (from the input of the output

buffer).

For more information on DCC see Section 6.7.3.

7.6.6

Disabling N2HET Outputs

Some applications require the N2HET outputs to be disabled under some fault condition. The N2HET

module provides this capability through the "Pin Disable" input signal. This signal, when driven low,

causes the N2HET outputs identified by a programmable register (HETPINDIS) to be tri-stated. For more

details on the "N2HET Pin Disable" feature, see the device-specific Terminal Reference Manual.

GIOA[5] is connected to the "Pin Disable" input for N2HET1, and GIOB[2] is connected to the "Pin

Disable" input for N2HET2.

134

Peripheral Information and Electrical Specifications

Submit Documentation Feedback

Product Folder Links: TMS570LS1114

TMS570LS1114 데이터시트(PDF) 134 Page - Texas Instruments