DA9155M

2.5 A Companion Charger for rapid charging

The junction temperature monitoring is also enabled in the reset mode. If a junction over-temperature

is detected during operation (TJUNC

≥ TJUNC_POR), DA9155M moves back to the reset mode.

10.8.3

Disabled

In the disabled mode DA9155M is fully functional but the Buck has not been enabled. An event is

fired when entering the disabled mode to notify the application processor that the slave charger is

DA9155M stays in the disabled mode, and an event is triggered.

DA9155M moves to the active mode when the Buck is enabled either by asserting the EN signal or

by setting the BUCK_EN register.

10.8.4

Active

In the active mode DA9155M is fully functional and the Buck is running.

DA9155M moves back to the disabled mode if the Buck is disabled, the safety timer expires, or if

Datasheet

v3.05

22-July-2016

CFR0011-120-00 Rev 5

24 of 36

© 2016 Dialog Semiconductor