AR0237CSSC12SPRA0-DR datasheet(33/38 Pages) ONSEMI

33 / 38 page

AR0237CS/D Rev. 4, 6/16 EN

©Semiconductor Components Industries, LLC, 2016.

AR0237CS: 1/2.7-Inch 2.1 Mp/Full HD Digital Image Sensor

Power-On Reset and Standby Timing

Power-Up Sequence

The recommended power-up sequence for the AR0237 is shown in Figure 15. The avail-

able power supplies (VDD_IO, VDD, VDD_SLVS, VDD_PLL, VAA, VAA_PIX) must have the

separation specified below.

1. Turn on VDD_PLL power supply.

2. After 100s, turn on VAA and VAA_PIX power supply.

3. After 100s, turn on VDD_IO power supply.

4. After 100s, turn on VDD power supply.

5. After 100s, turn on VDD_SLVS power supply.

6. After the last power supply is stable, enable EXTCLK.

7. Assert RESET_BAR for at least 1ms. The parallel interface will be tri-stated during this

time.

8. Wait 150000 EXTCLKs (for internal initialization into software standby.

9. Configure PLL, output, and image settings to desired values.

10. Wait 1ms for the PLL to lock.

11. Set streaming mode (R0x301a[2] = 1).

Figure 15:

Power Up

VDD_PLL (2.8)

VAA_PIX

VAA (2.8)

VDD_IO (1.8/2.8)

VDD (1.8)

VDD_SLVS (0.4)

EXTCLK

RESET_BAR

Hard Reset

Internal

Initialization

Software

Standby

PLL Lock

Streaming

AR0237CSSC12SPRA0-DR 데이터시트(PDF) 33 Page - ON Semiconductor