TCN75AVOA datasheet(12/40 Pages) MICROCHIP

12 / 40 page

TCN75A

DS21935D-page 12

 2010 Microchip Technology Inc.

FIGURE 4-1:

Device Addressing.

4.1.5

DATA VALID

After the Start condition, each bit of data in

transmission needs to be settled for a time specified by

tSU-DATA before SCL toggles from low-to-high (see

“Serial Interface Timing Specifications (Note 1)”

4.1.6

ACKNOWLEDGE (ACK)

Each receiving device, when addressed, is obliged to

generate an ACK bit after the reception of each byte.

The master device must generate an extra clock pulse

for ACK to be recognized.

The acknowledging device pulls down the SDA line for

tSU-DATA before the low-to-high transition of SCL from

the master. SDA also needs to remain pulled down for

tH-DATA after a high-to-low transition of SCL.

During read, the master must signal an End-of-Data

(EOD) to the slave by not generating an ACK bit (NAK)

once the last bit has been clocked out of the slave. In

this case, the slave will leave the data line released to

enable the master to generate the Stop condition.

2345

SCL

SDA

A2 A1 A0

Start

Address Byte

Slave

Address

R/W

TCN75A

Response

Code

Address

TCN75AVOA 데이터시트(PDF) 12 Page - Microchip Technology