HY29F080 datasheet(2/38 Pages) HYNIX

2 / 38 page

Rev. 6.1/May 01

HY29F080

To eliminate bus contention, the HY29F080 has

separate chip enable (CE#), write enable (WE#)

and output enable (OE#) controls.

The device is compatible with the JEDEC single

power-supply Flash command set standard. Com-

mands are written to the command register using

standard microprocessor write timings, from where

they are routed to an internal state-machine that

controls the erase and programming circuits.

Device programming is performed a byte at a time

by executing the four-cycle Program Command.

This initiates an internal algorithm that automati-

cally times the program pulse widths and verifies

proper cell margin.

The HY29F080’s sector erase architecture allows

any number of array sectors to be erased and re-

programmed without affecting the data contents

of other sectors. Device erasure is initiated by

executing the Erase Command. This initiates an

internal algorithm that automatically preprograms

the array (if it is not already programmed) before

executing the erase operation. During erase

cycles, the device automatically times the erase

pulse widths and verifies proper cell margin.

To protect data in the device from accidental or

unauthorized attempts to program or erase the

device while it is in the system (e.g., by a virus),

the device has a Sector Group Protect function

which hardware write protects selected sector

groups. The sector group protect and unprotect

features can be enabled in a PROM programmer.

Temporary Sector Unprotect, which requires a high

voltage, allows in-system erasure and code

changes in previously protected sectors.

Erase Suspend enables the user to put erase on

hold for any period of time to read data from, or

program data to, any sector that is not selected

for erasure. True background erase can thus be

achieved. The device is fully erased when shipped

from the factory.

Addresses and data needed for the programming

and erase operations are internally latched during

write cycles, and the host system can detect

completion of a program or erase operation by

observing the RY/BY# pin, or by reading the DQ[7]

(Data# Polling) and DQ[6] (toggle) status bits.

Reading data from the device is similar to reading

from SRAM or EPROM devices. Hardware data

protection measures include a low V

CC detector

that automatically inhibits write operations during

power transitions.

The host can place the device into the standby

mode. Power consumption is greatly reduced in

this mode.

BLOCK DIAGRAM

STATE

CONTROL

WE#

CE#

OE#

COMMAND

DQ[7:0]

CC DETECTOR

TIMER

ERASE VOLTAGE

GENERATOR AND

SECTOR SWITCHES

PROGRAM

VOLTAGE

GENERATOR

X-DECODER

Y-DECODER

8 Mbit FLASH

MEMORY

ARRAY

(16 x 512 Kbit

Sectors)

Y-GATING

DATA LATCH

I/O BUFFERS

I/O CONTROL

DQ[7:0]

A[19:0]

ELECTRONIC

RESET#

RY/BY#

HY29F080 데이터시트(PDF) 2 Page - Hynix Semiconductor

HY29F080 데이터시트(HTML) 2 Page - Hynix Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

데이터시트 다운로드

링크 URL