MPC823 datasheet(2/74 Pages) MOTOROLA

2 / 74 page

Communication Processor Module

16-380

MPC823 REFERENCE MANUAL

MOTOROLA

Each serial management controller supports the circuit interface and monitor channels of

the GCI bus. In which case, the serial management controller is connected to the TDM

channel in the serial interface. For testing purposes, the serial management controllers

support loopback and echo modes. The SMCx receiver and transmitter are double-buffered,

which provides an effective FIFO size (latency) of two characters. Refer to

Section 16.7 The Serial Interface with Time-Slot Assigner for details about configuring

the GCI interfaces.

The receive data source for the two serial management controller channels have different

pin options for each channel. SMC1 can either use the L1RXDA pin of the serial interface or

the SMRXD1 pin if it is connected to the NMSI. SMC2 can also use the L1RXDA pin of the

serial interface, but if you use the SMRXD2 pin the serial interface time-slot assigner

function is not available. Likewise, the transmit data source for SMC1 can be the L1TXDA

pin if a serial management controller is connected to the TDM or the SMTXD1 pin if it is

connected to the NMSI. SMC2 transmit data source can also be L1TXDA pin if the serial

management controller is connected to the TDM, but if you use the SMTXD2 pin, the serial

interface time-slot assigner function is not available.

If the serial management controllers are connected to the TDM, the SMCx receive and

transmit clocks can be independent from each other, as defined in the CRTA bit of the

SIMODE register. Refer to Section 16.7.5.2 Serial Interface Mode Register for more

information. However, if a serial management controller is connected to the NMSI, the SMCx

receive and transmit clocks must be connected to a single clock source called SMCLK,

which is an internal signal name for a clock that is generated from the bank of clocks.

SMCLK originates from an external pin or one of the two internal baud rate generators. Refer

to Section 16.7.8 Nonmultiplexed Serial Interface Configuration for more details.

Figure 16-113. Serial Management Controller Block Diagram

CONTROL

REGISTERS

U-BUS

RX DATA

TX DATA

SHIFTER

CONTROL

LOGIC

PERIPHERAL BUS

TXDx

RXDx

SYNC

CLOCK

MPC823 데이터시트(PDF) 2 Page - Motorola, Inc

MPC823 데이터시트(HTML) 2 Page - Motorola, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

데이터시트 다운로드

링크 URL