408- 10029

PIDG and PLASTI- GRIP Terminal and Splice Crimping Heads

Rev B

8

of 9

Tyco Electronics Corporation

7. REPLACEMENT AND REPAIR

Replacement parts and recommended spares are

listed in Figure 9. The recommended spares should

be stocked for immediate replacement.

Order replacement parts through your Tyco

Electronics Representative, or call 1--800--526--5142,

or send a facsimile of your purchase order to

1--717--986--7605, or write to:

CUSTOMER SERVICE (38--35)

TYCO ELECTRONICS CORPORATION

P.O. BOX 3608

HARRISBURG, PA 17105--3608

For further repair and replacement information,

call the Tyco Electronics Tooling Assistance Center at

the number at the bottom of page 1.

8. REVISION SUMMARY

S

Updated document to corporate requirements

Figure 8

Detail A

Inspection of Wire Barrel

Crimping Section

Detail B

Inspection of Insulation

Crimping Section

Wire Barrel Jaws

Bottomed But Not

Under Pressure

GO Element Must Pass

Completely Through the

Crimping Chamber

NO--GO Element May Enter

Partially, But Must Not Pass

Through the Crimping Chamber

Adjustment

Pins in

Position 1

(Ref)

Insulation Jaws Bottomed

But Not Under Pressure