ATtiny11 datasheet(8/61 Pages) ATMEL

8 / 61 page

Getting Started

2-2

AVR STK500 User Guide

1925C–AVR–3/03

2.3

Quick Start

The STK500 starter kit is shipped with an AT90S8515-8PC microcontroller in the socket

marked SCKT3000D3. The default jumper settings will allow the microcontroller to exe-

cute from the clock source and voltage regulator on the STK500 board.

The microcontroller is programmed with a test program that toggles the LEDs. The test

program in the AT90S8515 is similar to the example application code described in Sec-

tion 9. Connect the LEDs and switches and power up the STK500 to run the test

program in the AT90S8515.

Use the supplied 10-pin cables to connect the header marked “PORTB” with the header

marked “LEDS”, and connect the header marked “PORTD” with the header marked

“SWITCHES”. The connections are shown in Figure 2-1.

An external 10 - 15V DC power supply is required. The input circuit is a full bridge recti-

fier, and the STK500 automatically handles both positive or negative center connectors.

If a positive center connector is used, it can be impossible to turn the STK500 off since

the power switch disconnects the GND terminal. In this case, GND can be supplied

through the RS-232 cable shield if connected or through alternative GND connections.

Connect the power cable between a power supply and the STK500. Apply 10 - 15V DC

to the power connector. The power switch turns the STK500 main power on and off. The

red LED is lit when power is on, and the status LEDs will go from red, via yellow, to

green. The green LED indicates that the target V

CC is present. The program now run-

ning in the AT90S8515 will respond to pressed switches by toggling the LEDs.

Figure 2-1. Default Setup of STK500

The starter kit can be configured for various clock and power sources. A complete

description of the jumper settings is explained in paragraph 3.8 on page 3-15 and on the

reverse side of the starter kit.

ATtiny11 데이터시트(PDF) 8 Page - ATMEL Corporation