WM8510GEDSSLASHV datasheet(35/56 Pages) WOLFSON

35 / 56 page

Product Preview

WM8510

PP Rev 1.2 December 2004

Note that the speaker outputs and the mono output must be enabled for this function to work (see

Table 22). The CSB/GPIO pin has an internal de-bounce circuit when in this mode in order to prevent

the output enables from toggling multiple times due to input glitches.

This debounce circuit is

clocked from a slow clock with period 2

21 x MCLK, enabled using the SLOWCLKEN register bit.

GPIOPOL

CSB/GPIO

SPKNEN/

SPKPEN

MONOEN

SPEAKER

ENABLED

MONO

OUTPUT

ENABLED

Yes

Table 22 Output Switch Operation (GPIOSEL=001)

THERMAL SHUTDOWN

The speaker outputs can drive very large currents. To protect the WM8510 from overheating a

thermal shutdown circuit is included. If the device temperature reaches approximately 125

0C and the

thermal shutdown circuit is enabled (TSDEN=1) then the speaker amplifiers will be disabled if

TSDEN is set. The thermal shutdown may also be configured to generate an interrupt. See the GPIO

and Interrupt Controller section for details.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R49

Output control

TSDEN

Thermal Shutdown Enable

0 : thermal shutdown disabled

1 : thermal shutdown enabled

Table 23 Thermal Shutdown

SPEAKER OUTPUT

SPKOUTP/N can differentially drive a mono 8

Ω Bridge Tied Load (BTL) speaker as shown below.

Figure 17 Speaker Output Connection

WM8510GEDS/V 데이터시트(PDF) 35 Page - Wolfson Microelectronics plc

WM8510GEDS/V 데이터시트(HTML) 35 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

데이터시트 다운로드

링크 URL