L3GD20H datasheet(36/52 Pages) STMICROELECTRONICS

36 / 52 page

L3GD20H

36/52

DocID023469 Rev 2

The device contains a set of registers which are used to control its behavior and to retrieve

angular rate data. The registers address, made of 7 bits, is used to identify them and to write

the data through serial interface.

7.1

WHO_AM_I (0Fh)

Device identification register.

7.2

CTRL1 (20h)

DR<1:0> is used to set ODR selection. BW <1:0> is used to set bandwidth selection.

In the following table are reported all frequency resulting in combination of DR / BW bits.

Table 18. WHO_AM_I register

10101

Table 19. CTRL1 register(1)

Xen, Yen, Zen enable X, Yor Z register in level sensitive trigger mode. Once LVLen bit = 1, DEN level

replaces the LSB of X, Y or Z axes and all axis are available for reading.

DR1

DR0

BW1

BW0

Zen

Xen

Yen

Table 20. CTRL1 description

DR1-DR0

Output data rate selection. Refer to

Table 21

BW1-BW0

Bandwidth selection. Refer to

Table 21

Power mode. Default value: 0. Refer to

Table

0= Power Down

1= Normal Mode

(For Sleep Mode set {PD:Zen:Yen:Xen} to {1000})

Zen

Z axis enable. Default value: 1

(0: Z axis disabled; 1: Z axis enabled)

Yen

Y axis enable. Default value: 1

(0: Y axis disabled; 1: Y axis enabled)

Xen

X axis enable. Default value: 1

(0: X axis disabled; 1: X axis enabled)

L3GD20H 데이터시트(PDF) 36 Page - STMicroelectronics

L3GD20H 데이터시트(HTML) 36 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

데이터시트 다운로드

링크 URL