STNRGPF01 datasheet(24/40 Pages) STMICROELECTRONICS

24 / 40 page

Electrical characteristics

STNRGPF01

24/40

DocID030377 Rev 2

5.2

Absolute maximum ratings

Stresses above those listed as 'absolute maximum ratings' may cause permanent damage

to the device. This is a stress rating only and the functional operation of the device under

these conditions is not implied. Exposure to maximum rating conditions for extended

periods may affect the device reliability.

Table 4. Voltage characteristics

Symbol

Ratings

Min.

Max.

Unit

VDDX - VSSX Supply voltage(1)

1. All power VDDX (VDD, VDDA) and ground VSSX (VSS, VSSA) pins must always be connected to the external

power supply.

-0.3

6.5

VIN

Input voltage on any other pin(2)

2. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN > VDD while a negative injection is induced by VIN < VSS.

VSS - 0.3

VDD + 0.3

VDD - VDDA Variation between different power pins

VSS - VSSA Variation between all the different ground pins(3)

3. VSS and VSSA signals must be interconnected together with a short wire loop.

-50

VESD

Electrostatic discharge voltage

Refer to Table 15 on page 33.

Table 5. Current characteristics

Symbol

Ratings

Max.(1)

1. Data based on characterization results, not tested in production.

Unit

IVDDX

Total current into VDDX power lines(2)

2. All power VDDX (VDD, VDDA) and ground VSSX (VSS, VSSA) pins must always be connected to the external

power supply.

100

IVSSX

Total current out of VSSX power lines(2)

100

IIO

Output current sunk by any I/Os and control pin

Ref. to Table 12 on

page 28

Output current source by any I/Os and control pin

IINJ(PIN)(3), (4)

3. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN > VDD while a negative injection is induced by VIN < VSS.

4. Negative injection disturbs the analog performance of the device.

Injected current on any pin

± 4

IINJ(TOT)(3), (4), (5)

5. When several inputs are submitted to a current injection, the maximum IINJ(PIN) is the absolute sum of the

positive and negative injected currents (instantaneous values). These results are based on

characterization with the IINJ(PIN) maximum current injection on four I/O port pins of the device.

Sum of injected currents

± 20

Table 6. Thermal characteristics

Symbol

Ratings

Max.

Unit

TSTG

Storage temperature range

-65 to 150

ºC

Maximum junction temperature

150

STNRGPF01 데이터시트(PDF) 24 Page - STMicroelectronics

STNRGPF01 데이터시트(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

데이터시트 다운로드

링크 URL