STM32F078CB datasheet(27/120 Pages) STMICROELECTRONICS

27 / 120 page

DocID026006 Rev 4

27/120

STM32F078CB, STM32F078RB, STM32F078VB

Functional overview

overhead. It has a clock domain independent from the CPU clock, allowing the HDMI_CEC

controller to wakeup the MCU from Stop mode on data reception.

3.20

Universal serial bus (USB)

The STM32F078CB/RB/VB embeds a full-speed USB device peripheral compliant with the

USB specification version 2.0. The internal USB PHY supports USB FS signaling,

embedded DP pull-up and also battery charging detection according to Battery Charging

Specification Revision 1.2. The USB interface implements a full-speed (12 Mbit/s) function

interface with added support for USB 2.0 Link Power Management. It has software-

configurable endpoint setting with packet memory up-to 1 KB and suspend/resume support.

It requires a precise 48 MHz clock which can be generated from the internal main PLL (the

clock source must use an HSE crystal oscillator) or by the internal 48 MHz oscillator in

automatic trimming mode. The synchronization for this oscillator can be taken from the USB

data stream itself (SOF signalization) which allows crystal-less operation.

3.21

Clock recovery system (CRS)

The STM32F078CB/RB/VB embeds a special block which allows automatic trimming of the

internal 48 MHz oscillator to guarantee its optimal accuracy over the whole device

operational range. This automatic trimming is based on the external synchronization signal,

which could be either derived from USB SOF signalization, from LSE oscillator, from an

external signal on CRS_SYNC pin or generated by user software. For faster lock-in during

startup it is also possible to combine automatic trimming with manual trimming action.

3.22

Serial wire debug port (SW-DP)

An ARM SW-DP interface is provided to allow a serial wire debugging tool to be connected

to the MCU.

STM32F078CB 데이터시트(PDF) 27 Page - STMicroelectronics