CS5372 datasheet(9/22 Pages) CIRRUS

9 / 22 page

CS5371/CS5372

DS255PP2

3. MODULATOR PERFORMANCE

Figures 4 and 5 illustrate the spectral performance

of the CS5371/CS5372 modulators when com-

bined with the CS5376 digital filter. The plots

were created from ten averaged 1024 point FFTs.

3.1.

Full Scale Signal Performance

Figure 4 illustrates the full-scale signal perfor-

mance of the CS5371/CS5372 modulators and

CS5376 digital filter using a 31.25 Hz input signal

and a 1000 sps output word rate. The outstanding

full-scale

signal

characteristics

the

CS5371/CS5372 modulators are shown, with no

harmonic components exceeding -120 dB. Analy-

sis of this data set yields a signal-to-noise ratio

(SNR) of 124.0 dB and a signal-to-distortion ratio

(SDR) of 119.0 dB. Note that the full-scale signal

peak in Figure 4 shows a slightly reduced ampli-

tude due to spectral smearing associated with the

FFT windowing function, and is a purely digital

phenomenon.

3.2.

Noise Performance

Figure 5 illustrates the noise performance of the

CS5371/CS5372 modulators and CS5376 digital

filter using a 31.25 Hz -24 dB input signal and a

1000 sps output word rate. The outstanding noise

characteristics of the CS5371/CS5372 modulators

are shown, with the averaged noise components

consistently below the -150 dB level. Analysis of

this data set yields a dynamic range of 124.7 dB.

Note that the 0.7 dB variation between the signal-

to-noise calculation in Figure 4 and the dynamic

range calculation in Figure 5 is not modulator de-

pendent and results from jitter in the test signal

generator when producing a full scale output, as ev-

idenced by the skirt surrounding the signal peak be-

low the -140 dB level in Figure 4.

4. SIGNAL INPUTS

The CS5371/CS5372 modulators use a switched

capacitor architecture for the analog signal inputs,

which has increased jitter tolerance relative to con-

tinuous time signal input stages.

4.1.

Differential Inputs - INR+/-, INF+/-

The analog signal inputs are differential and use

four pins: INR+, INR-, INF+, and INF-. The posi-

tive inputs, INR+ and INF+, are connected to the

positive half of the differential signal, while the

negative inputs, INR- and INF-, are connected to

Figure 4. 1024 Point FFT plot with a 31.25 Hz

input at Full Scale, ten averages

-200

-180

-160

-140

-120

-100

-80

-60

-40

-20

100

150

200

250

300

350

400

450

500

S/N = 124.0 dB

S/D = 119.0 dB

-200

-180

-160

-140

-120

-100

-80

-60

-40

-20

100

150

200

250

300

350

400

450

500

Dynamic Range = 124.7 dB

Figure 5. 1024 Point FFT plot with a 31.25 Hz

input at -24 dB, ten averages

CS5372 데이터시트(PDF) 9 Page - Cirrus Logic

CS5372 데이터시트(HTML) 9 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

데이터시트 다운로드

링크 URL