M950X0-W datasheet(13/46 Pages) STMICROELECTRONICS

13 / 46 page

DocID6512 Rev 13

13/46

M950x0-W M950x0-R M950x0-DF

Operating features

4.1

Hold condition

The Hold (HOLD) signal is used to pause any serial communications with the device without

resetting the clocking sequence.

During the Hold condition, the Serial Data Output (Q) is high impedance, and Serial Data

Input (D) and Serial Clock (C) are Don’t Care.

To enter the Hold condition, the device must be selected, with Chip Select (S) low.

Normally, the device is kept selected, for the whole duration of the Hold condition.

Deselecting the device while it is in the Hold condition has the effect of resetting the state of

the device, and this mechanism can be used if it is required to reset any processes that had

been in progress.

The Hold condition starts when the Hold (HOLD) signal is driven low at the same time as

Serial Clock (C) already being low (as shown in Figure 5: Hold condition activation).

The Hold condition ends when the Hold (HOLD) signal is driven high at the same time as

Serial Clock (C) already being low.

Figure 5: Hold condition activation also shows what happens if the rising and falling edges

are not timed to coincide with Serial Clock (C) being low.

Figure 5. Hold condition activation

4.2

Status register

Figure 6 shows the position of the Status register in the control logic of the device. This

M950X0-W 데이터시트(PDF) 13 Page - STMicroelectronics