LP5569RTWR datasheet(16/86 Pages) TI1

16 / 86 page

LP5569

SNVSAP8 – JULY 2017

www.ti.com

Product Folder Links: LP5569

Submit Documentation Feedback

Feature Description (continued)

Figure 8. Simplified Data Flow of Master Fader

8.3.1.2.3.1

PWM Master Fader on EN/PWM Pin

The EN/PWM pin provides a dual-function input. On power up, the pin functions as the device enable (EN)

function, where the first rising edge enables the LP5569 device. After the chip_en bit is set high in the CONFIG

(addresses 07h–0Fh) MF_MAPPINGx bits = 5h configures LEDx for PWM control.

The PWM input is a sampled input which converts the input duty-cycle information into an 11-bit code. The use

of a sampled input eliminates any noise and current ripple that is typical of traditional PWM-controlled LED

drivers. The PWM input uses logic-level thresholds with VIH_MIN = 1.25 V and VIL_MAX = 0.4 V. Because this is a

sampled input, there are limits on the maximum PWM input frequency as well as the resolution that can be

achieved.

8.3.1.2.3.1.1

PWM Master Fader Resolution and Input Frequency Range

The PWM input frequency range is 100 Hz to 20 kHz. To achieve the full 11-bit maximum resolution of PWM

duty cycle to the code, the input PWM duty cycle must be

≥ 11 bits, and the PWM sample period (1 / fSAMPLE)

must be smaller than the minimum PWM input pulse duration. Figure 9 shows the possible brightness code

resolutions based on the input PWM frequency.

LP5569RTWR 데이터시트(PDF) 16 Page - Texas Instruments