AR0230CS

www.onsemi.com

2

ORDERING INFORMATION

Table 2. AVAILABLE PART NUMBERS

Part Number

Product Description

Orderable Product Attribute De-

scription †

AR0230CSSC00SUEA0−DRBR

2 Mp 1/3” CIS RGB, 0deg CRA, iBGA Package

Drypack, Anti−Reflective Glass

AR0230CSSC00SUEAH3−GEVB

RGB, 0deg CRA, Headboard

Headboard

AR0230CSSC12SUEA0−DR

2 Mp 1/3” CIS RGB, 12deg CRA, iBGA Package

Drypack

AR0230CSSC12SUEAH3−GEVB

RGB, 12deg CRA, Headboard

Headboard

†For information on tape and reel specifications, including part orientation and tape sizes, please refer to our Tape and Reel Packaging

Specification Brochure, BRD8011/D.

See the ON Semiconductor Device Nomenclature

document (TND310/D) for a full description of the naming

convention used for image sensors. For reference

documentation, including information on evaluation kits,

please visit our web site at www.onsemi.com.

GENERAL DESCRIPTION

The ON Semiconductor AR0230CS can be operated in its

default mode or programmed for frame size, exposure, gain,

and other parameters. The default mode output is a

1080p−resolution image at 60 frames per second (fps)

through the HiSPi port. In linear mode, it outputs 12−bit or

10−bit A−Law compressed raw data, using either the parallel

or serial (HiSPi) output ports. In high dynamic range mode,

it outputs 12−bit compressed data using parallel output. In

HiSPi mode, 12− or 14−bit compressed, or 16−bit linearized

data may be output. The device may be operated in video

(master) mode or in single frame trigger mode.

FRAME_VALID and LINE_VALID signals are output on

dedicated pins, along with a synchronized pixel clock in

parallel mode.

The AR0230CS includes additional features to allow

application−specific tuning: windowing and offset, auto

black level correction, and on−board temperature sensor.

Optional register information and histogram statistic

information can be embedded in the first and last 2 lines of

the image frame.

The AR0230CS is designed to operate over a wide

temperature range of −30

°C to +85°C ambient.

FUNCTIONAL OVERVIEW

The AR0230CS is a progressive−scan sensor that

generates a stream of pixel data at a constant frame rate. It

uses an on−chip, phase−locked loop (PLL) that can be

optionally enabled to generate all internal clocks from a

single master input clock running between 6 and 48 MHz.

The

maximum

output

pixel

rate

is

148.5

Mp/s,

corresponding to a clock rate of 74.25 MHz. Figure 1 shows

a block diagram of the sensor configured in linear mode, and

in HDR mode.