SCF5250 datasheet(13/48 Pages) MOTOROLA

13 / 48 page

Signal Descriptions

SCF5250 Integrated ColdFire® Microprocessor Data Sheet, Rev. 1.1

Freescale Semiconductor

4.3.1

Address Bus

•

The address bus provides the address of the byte or most significant byte of the word or longword

being transferred.The address lines also serve as the DRAM address pins, providing multiplexed

row and column address signals.

•

Bits 23 down to 1 and 24 of the address are available. A24 is intended to be used with 256 Mbit

DRAM’s. Signals are named:

— A[23:1]

— A20/24

4.3.2

Read-Write Control

This signal indicates during any bus cycle whether a read or write is in progress. A low is write cycle and

a high is a read cycle.

4.3.3

Output Enable

The OE signal is intended to be connected to the output enable of asynchronous memories connected to

chip selects. During bus read cycles, the ColdFire processor will drive OE low.

4.3.4

Data Bus

The data bus (D[31:16]) is bi-directional and non-multiplexed. Data is registered by the SCF5250 on the

rising clock edge. The data bus uses a default configuration if none of the chip-selects or DRAM bank

match the address decode. All 16 bits of the data bus are driven during writes, regardless of port width or

operand size.

4.3.5

Transfer Acknowledge

The TA/GPIO12 pin is the transfer acknowledge signal.

4.4

SDRAM Controller Signals

The following SDRAM signals provide a glueless interface to external SDRAM. An SDRAM width of 16

bits is supported and can access as much as 32MB of memory. ADRAMs are not supported.

Table 4. SDRAM Controller Signals

SDRAM Signal

Description

Synchronous DRAM row address strobe

The SDRAS/GPIO59 active low pin provides a seamless interface to the

RAS input on synchronous DRAM

Synchronous DRAM Column Address Strobe The SDCAS/GPIO39 active low pin provides a seamless interface to

CAS input on synchronous DRAM.

Synchronous DRAM Write

The SDWE/GPIO38 active-low pin is asserted to signify that a SDRAM

write cycle is underway. This pin outputs logic ‘1’ during read bus cycles.

SCF5250 데이터시트(PDF) 13 Page - Motorola, Inc

SCF5250 데이터시트(HTML) 13 Page - Motorola, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48

데이터시트 다운로드

링크 URL