| 전자부품 데이터시트 검색엔진 |
|
WM9714CLGEFL/V 데이터시트(PDF) 24 Page - Cirrus Logic |
|
|
|||||||||||||||||||||||||||||
WM9714CLGEFL/V 데이터시트(HTML) 24 Page - Cirrus Logic |
|
24 / 120 page ![]() WM9714L 24 Rev 4.0 PLL REGISTER PAGE ADDRESS MAPPING The clock division control bits SPLL[6:0] and the PLL fractional N division bits are accessed through register 46h using a sub-page address system. The 3-bit pager address allows 8 blocks of 4-bit data words to be accessed whilst the register address is set to 46h. This means that when register address 46h is selected a further 7 cycles of programming are required to set all of the page data bits. Control bit allocation for these page addresses is described in Table 6. PAGE ADDRESS BIT LABEL DEFAULT DESCRIPTION 111 31:28 SPLL[6:4] 0h Clock division control bus SPLL[6:0]. Clock divider reads this control word if PLL is enabled. Bits [6:4] and [3:0] have the same functionality as 44h [14:12] and [11:8] respectively 110 27:24 SPLL[3:0] 0h 101 23:22 Reserved 0h Reserved bits 21:20 K[21:0] 0h Sigma Delta Modulator control word for fractional N division. Division resolution is 1/222 100 19:16 0h 011 15:12 0h 010 11:8 0h 001 7:4 0h 000 3:0 SPLL[3:0] 0h Table 6 Pager Control Bit Allocation Powerdown for the PLL and internal clocks is via registers 26h and 3Ch (see Table 7). REGISTER ADDRESS BIT LABEL DEFAULT DESCRIPTION 26h 13 PR5 1 (Off) Internal Clock Disable Control 1 = Disabled 0 = Enabled 3Ch 9 PLL 1 (Off) PLL Disable Control 1 = Disabled 0 = Enabled N.B. both PR5 and PLL must be asserted low before PLL is enabled Table 7 PLL Powerdown Control DIGITAL INTERFACES The WM9714L has two interfaces, a data and control AC’97 interface and a data only PCM interface. The AC’97 interface is available through dedicated pins (SDATAOUT, SDATAIN, SYNC, BITCLK and RESETB) and is the sole control interface with access to all data streams on the device except for the Voice DAC. The PCM interface is available through the GPIO pins (PCMCLK, PCMFS, PCMDAC and PCMADC) and provides access to the Voice DAC. It can also transmit the data from the Stereo ADC. This can be useful, for example, to allow both sides of a phone conversation to be recorded by mixing the transmit and receive paths on one of the ADC channels and transmitting it over the PCM interface. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |