AX58200 datasheet(38/180 Pages) ASIX

38 / 180 page

AX58200

EtherCAT Slave Controller SoC

2.2.2.1 nRESET Reset

The nRESET reset means to generate a reset signal by pulling low nRESET pin, which is an asynchronous reset

input pin and can be used to reset system at any time. When the nRESET voltage is lower than 0.2 VDD and the

state keeps longer than 32 us (glitch filter), chip will be reset. The nRESET reset will control the chip in reset state

until the nRESET voltage rises above 0.7 VDD and the state keeps longer than 32 us (glitch filter). The

PINRF(SYS_RSTSTS[1]) will be set to 1 if the previous reset source is nRESET reset. Figure 2.2-2 shows the

nRESET reset waveform.

Figure 2.2-2: nRESET Reset Waveform

2.2.2.2 Power-on Reset (POR)

The Power-on reset (POR) is used to generate a stable system reset signal and force the system to be reset when

power-on to avoid unexpected behavior of MCU. When applying the power to MCU, the POR module will detect

the rising voltage and generate reset signal to system until the voltage is ready for MCU operation. At POR reset,

the PORF(SYS_RSTSTS[0]) will be set to 1 to indicate there is a POR reset event. The PORF(SYS_RSTSTS[0])

bit can be cleared by writing 1 to it. Figure 2.2-3 shows the power-on reset waveform.

VDD

VPOR

Power-on

Reset

0.1V

Figure 2.2-3: Power-on Reset (POR) Waveform

AX58200 데이터시트(PDF) 38 Page - ASIX Electronics Corporation