JS28F320J3A-150 datasheet(45/72 Pages) INTEL

45 / 72 page

256-Mbit J3 (x8/x16)

Datasheet

The only other valid commands while block erase is suspended are Read Query, Read Status

command is written to the flash memory, the WSM will continue the block erase process. SR.6 and

SR.7 will automatically clear and STS (in default mode) will return to VOL. After the Erase

Resume command is written, the device automatically outputs SRD when read (see Figure 23,

“Block Erase Suspend/Resume Flowchart” on page 64). VPEN must remain at VPENH (the same

VPEN level used for block erase) while block erase is suspended. Block erase cannot resume until

program operations initiated during block erase suspend have completed.

12.3

Erase Resume

To resume (i.e., continue) an erase suspend operation, execute the Erase Resume command. The

Resume command can be written to any device address. When a program operation is nested

within an erase suspend operation and the Program Suspend command is issued, the device will

suspend the program operation. When the Resume command is issued, the device will resume the

program operations first. Once the nested program operation is completed, an additional Resume

command is required to complete the block erase operation. The device supports a maximum

suspend/resume of two nested routines. See Figure 22, “Block Erase Flowchart” on page 63.

JS28F320J3A-150 데이터시트(PDF) 45 Page - Intel Corporation